|
Post by Andrey on Feb 5, 2005 12:15:10 GMT -8
HELLO IF CAN GIVE THE INFORMATION, WHAT MOST SIMPLE METHOD IT IS POSSIBLE TO TRANSFER THE SIZES OF THE AUTOMOBILE(CAR) TO THE COMPUTER FOR CREATION 3D MODELS, FOR THE OPPORTUNITY OF MANUFACTURING OF MODEL OF THE SPOILER OF THE BOOT LID OF THE AUTOMOBILE(CAR)... I AM SORRY FOR THE DISGUSTING ENGLISH, THE TEXT IS WRITTEN BY MEANS OF THE TRANSLATOR COMPUTER YOURS FAITHFULLY ANDREY
|
|
Seb
Full Member
Posts: 101
|
Post by Seb on Feb 7, 2005 7:09:10 GMT -8
Hello Andrey, if I understand, you want to take measurements of a real car, transfer it to your computer to create your spoiler/part, and finaly build it ? This process is going to be expensive , you'll need time, money for the machining etc.... I'm not saying it's stupid, maybe it's a good choice regarding your situation, but there are for sure easier process to get to your goal... I think if you look for the most simple way to do it then you don't really need to use a computer. If you look the "clay model competition" on this forum, you'll see you can create a real 3D model from a simple drawing. One of the other good points is that your prototype will only cost you time, and you will be able to make a mold of this model to cast it into a real part. Then it's up to you to chose if you want to do it in fiberglass, carbon, kevlar, polyurethane resin etc .... I think Steve will be able to explain it more clearly. If you have questions just post it here. Good luck Seb
|
|
|
Post by Andrey on Feb 12, 2005 9:56:40 GMT -8
THANK YOU ;D
|
|
|
Post by Steve Austin on Feb 21, 2005 7:13:48 GMT -8
|
|